Alesis MidiVerb 4 Notes
This is notes straight from the Alesis manual.
Auto input level settings:
- Simultaneously press both [INPUT] and [OUTPUT] buttons.
- Feed signal to the MidiVerb 4’s input(s). The Auto Input function will “listen” to the signal at its input(s) for about 5 seconds, and adjust the input levels for both channels.
Switching Between Preset and User Banks:
- To instantly switch between the Preset and User banks, press the [PROG] button.
Bypass preset:
- Preset 00 is setup as a “Bypass Program”, meaning that the dry, uneffected signal being sent to the MidiVerb 4’s input(s) is passing through and none of the effect’s output can be heard.
Saving Edited Programs:
- Press [STORE]. The [STORE] button will flash, and the display will read: Store as X XX (nnnnnnnn)? …whereas XXX is a Program location number from 00—127 in the User bank, and nnnnnnnn is the Program’s name.
- Use the [VALUE] knob to select which location (00—127) you wish to store the
- selected Program into.
- Change the Program’s name by pressing [A/NAME].
- Press [STORE] again. The [STORE] button’s LED will momentarily flash quickly, while the display reads: Program nnnnnnnn Stored! …whereby nnnnnnnn is the Program’s name. The [STORE] button will turn off and the display will revert to wherever it was before [STORE] was pressed for the first time.
Bypassing Effects: (There are no “trails” When bypassed the effect is cut off)
- By simultaneously pressing both the [PROG] and [UTIL] buttons on the front
- panel
- Connecting a footswitch to the [FOOTSWITCH] jack and pressing the
- footswitch.
Setup a Footswitch:
- Press [UTIL]. The [UTIL] button will light.
- Press [EDIT/PAGE] until page 1 is selected. The display will read: Footswitch Dry Defeat
- Press [B] to select the Footswitch parameter.
- Turn the [VALUE] knob to set the Footswitch parameter to Bypass mode (bYP).
Reset Unit to Factory Default:
- Hold ‘D’ and ‘PROG’ while powering on.